[DeTomaso] 10 Quart Oil Pan & Removeable X-Member

[Michael Shortt]

I have just received the 10 qt. pan that i bought from another forum member
as well as the crossmember.

I have the following questions.

1.  Is there a step by step guide available to do this? ( I will be taking
photos and documenting the whole thing )
2.  Are there alternatives to the oil pan gasket ( including brands ) that
are superior?
3.  Is there a drawing of the E Brqke bracket that must be removed-changed,
etc.
4. What or How how should I treat the dipstick ( don't go there ) in
relation to the deeper pan?
5.  I'm assuming that we should braze on an ext piece, if so, how long?
6.  If I'm not smoking, is it really worth pulling the bearings out to have
a look?
7. Anything I left out?


I was told that this was about a 2.5 hour job if one were alone on the
garage floor.
So if I were at a shop with a proper lift, any guesstimates?


Thanks,



-- 
Michael L. Shortt
Savannah, Georgia


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you